Using The Usb Memory; Notes On Use; Usb Memory That Can Be Used With The Projector; Attaching The Usb Memory - Panasonic PT-MZ570 Operating Instructions Manual

Using the USB memory

This projector supports the attachment of the USB memory. Attach the USB memory to the <VIEWER/PAIRING>
terminal when using the Memory Viewer function, the pairing function, or the data cloning function.
Note
f For details on the Memory Viewer function, refer to "Projecting with MEMORY VIEWER input" (x page 186).
f For pairing of the projector and the USB memory, refer to "Using the pairing function" (x page 194).
f For how to use the image transfer application software "Plug and Share" allowing to easily connect via the wireless LAN by pairing the
commercially available USB memory with the projector, refer to following URL.
https://panasonic.net/cns/projector/
For the method of pairing the projector and the USB memory, refer to "Using the pairing function" (x page 194). By pairing, the connection
information between the image transfer application software "Plug and Share", and the projector and the USB memory is written into the
USB memory.
f For the data cloning function, refer to the [PROJECTOR SETUP] menu → [DATA CLONING] (x page 127).

Notes on use

Observe following.
f Do not disassemble or modify the USB memory.
f Do not apply strong impact on the USB memory.
f Do not pour liquid such as water or get it wet.
f Do not place foreign object into the terminal section.
f Do not touch the metal terminal with hand or metal.
f Do not leave the USB memory in a place with high humidity or dust.
f Do not leave the USB memory in a place where static electricity or electromagnetic radiation is generated.
f Store the USB memory appropriately in a location that small children cannot reach.
f Immediately remove the USB memory from the projector when smoke or odor is noticed, and contact the
manufacturer.
f Do not remove the USB memory from the projector while reading or writing the data.

USB memory that can be used with the projector

This projector supports the commercially available USB 2.0 compatible USB memory formatted in FAT16 or
FAT32.
f Only the single partition structure is supported.
Note
f The USB memory with a security function cannot be used for pairing.
f Free space of approximately 30 MB is required in the USB memory used for pairing.

Attaching the USB memory

1) Insert the USB memory all the way in to the <VIEWER/PAIRING> terminal.
Attention
f Take care of the orientation of the terminal when inserting the USB memory so that it will not get damaged.
f Do not use a USB extension cable or a USB hub, and directly insert the USB memory into the <VIEWER/PAIRING> terminal of the
projector.
f Do not insert the USB memory into the <DC OUT> terminal. The USB memory cannot be used on the <DC OUT> terminal.
Note
f The USB memory can be attached even when the projector is turned on.
f The pairing data is written to the USB memory when the pairing function is used. If there is a write protection switch on the USB memory to
be used, set it so that data can be written.
70 - ENGLISH
Chapter 3 Basic Operations — Using the USB memory