Connecting Example: Av Equipment - Panasonic PT-MZ570 Operating Instructions Manual

<HDMI 1 IN> terminal/<HDMI 2 IN> terminal pin assignments and signal names
Outside view
Even-numbered pins of (2) to (18)
(2) (18)
(1) (19)
Odd-numbered pins of (1) to (19)

Connecting example: AV equipment

Attention
f Be sure to use one of the following when connecting a VCR.
g Use a VCR with built-in time base corrector (TBC).
g Use a time base corrector (TBC) between the projector and the VCR.
f The image may be disrupted when nonstandard burst signal is connected. In such a case, connect the time base corrector (TBC) between
the projector and the external devices.
Note
f For the HDMI cable, use an HDMI High Speed cable that conforms to the HDMI standards. If a cable that does not conform to the HDMI
standards is used, images may be interrupted or may not be projected.
f The <HDMI 1 IN>/<HDMI 2 IN> terminals can be connected to an external device with the DVI-D terminal by using an HDMI/DVI conversion
cable. However, this may not function properly for some external devices, and image may not be projected.
f The projector does not support VIERA Link (HDMI).
Chapter 2 Getting Started — Connecting
Pin No. Signal name
(1) T.M.D.S data 2+
(2) T.M.D.S data 2 shield
(3) T.M.D.S data 2-
(4) T.M.D.S data 1+
(5)
T.M.D.S data 1 shield
(6) T.M.D.S data 1-
(7)
T.M.D.S data 0+
(8) T.M.D.S data 0 shield
(9)
T.M.D.S data 0-
(10) T.M.D.S clock+
VCR
(with built-in TBC)
Pin No. Signal name
(11) T.M.D.S clock shield
(12) T.M.D.S clock-
(13)
(14)
(15)
(16)
DDC/CEC
(17)
(18)
(19)
Hot plug detection
Blu-ray disc player
Audio device
ENGLISH - 53
CEC
―
SCL
SDA
GND
+5 V