11
LIGHT BULB AND LENS INSTALLATION
...
1. Install light bulb(s) into socket(s).
Do Not use short neck bulb(s).
• Use bulb(s) rated for:
– rough service.
– vibration.
26
– appliances.
• 100 watt maximum.
2. Bend two (2) slotted tabs up. This will activate
the "living hinge" of the lens (Fig. 11-1).
NOTE: The following steps use the screws from the
Blue Parts Bag that were set aside earlier.
3. Start two (2) No. 8 x 3/4" hex head screws into
bottom holes of panel (Fig. 11-2).
• Slide slotted tabs up behind hex head screws.
• Tighten hex head screws.
4. Align lens holes and holes of panel.
• Insert and tighten a No. 8 x 5/8" pan head
screw into each round lens hole and tighten,
NOTE: Screw heads fit completely into recess of
lens tab.
FOR HELP-1.800.354.3643 OR GENIECOMPANY.COM
Bend tabs up (2)
Slotted tabs
Fig. 11-1
[ 10 ]
Pan head
screws
Fig. 11-2
[ 9 ]
Hex Head Screw
No. 8 x 3/4"
[ 10 ]
Pan Head
Phillips Screw
No. 8 x 5/8"
Bend tabs up
[ 9 ]
Hex head
screws