Remote Control Battery Replacement; Light Bulb/Lens Installation - Genie GCG350L Manual

1. Programming.
• Foreachbutton.
-Program eachbuttonseparately.
- Followsinglebuttonremoteprocedure
(previous page)for eachbutton.
2. Operating.
• Sameas singlebuttonremote.
1. Clearmemory.
• Pressandholdlearncodebutton
(on
power
head) for 10 seconds or until Indicator LED
goes out.
• Program remaining or new remote controls as
done previously. Your door operator will no
longer recognize any signal received from the
missing remote control, or any other which has
not been reprogrammed.
1. Battery replacement.
• Use coin, ball-point pen or similar device.
-Gently push straight in on battery cover lock
tab as shown (Fig. 9-1).
• Flip open battery cover.
-Remove old battery.
• Make sure new battery is facing proper direction
(Match battery polarity with symbols inside
battery cover) (fig. 9-2).
-Recommended replacement battery is
Eveready A-23, 12 volt.
• Slip new battery into place.
-Snap battery cover shut.
• Operate remote to make sure it is working
properly. (No re-programming is needed.)
2. Visor clip.
• Slide visor clip into back of remote control.
-It will snap into place (Fig, 9-3).
9
1. Light bulb.
• Recommendations.
-Do not use a short neck bulb.
-Light bulb should be no more than 100 Watts.
- Use a heavy duty service bulb for longer life.
• Screw bulb into socket.
2. Lens.
• Slide hinges into slots on motor cover (Fig. 10-1).
• Swing lens up.
- Fit tabs into slots provided on power head.