Battery & Visor Clip Installation - Genie GPS-IC Owner's Manual

• Press and release a remote control button.
– LED on power head stops blinking.
• Press and release same remote button again.
– LED goes out. Remote is now programmed.
2. Program multi-button remote control
• Repeat step 1 ("program one-button remote" for
each button).
NOTE: Each button on a multi-button remote control
is for a different operator.
3. Operate remote control
• Point remote control at door
– Door moves
• Press button again
– Door stops
• Press button again
– Door reverses
NOTE: Door automatically stops at end of open or
close cycle.
4. Erasing all receiver memory
• Press and hold learn code button on
power head
– 10 seconds or until light goes out
– Memory is erased
• Program door operator again
• Press remote control button once within
30 seconds
– LED on power head stays lit
• Press remote control button again
– LED on power head goes out and remote
control is programmed
NOTE: If LED blinks approximately 4 times per
second, programming has stopped. If programming
stops, repeat above steps.
10
BATTERY / VISOR CLIP INSTALLATION
...
1. Turn remote control upside down (Fig. 10-1)
2. Battery replacement (your remote control is
battery powered).
• Gently push straight IN on tab as shown
(Fig. 10-1).
– use ball point pen, coin or small screwdriver.
– battery cover snaps open.
• Install new battery in same position.
– use A23,
3. Attach visor clip to remote control (Fig. 10-2)
• Slide visor clip into back of case until it snaps
into place.
4. Remote control operation
• Point remote control at the garage door and
press the button. Door will move.
• Press remote control button again and door
will stop.
• Press remote control button again and the door
will move the other way. The door automatically
stops at the end of the open or close cycle.
12 Volt battery.
Radio
signal
indicator
Learn
code
button
STEALTH
1
2
NEC
CLASS 2
3
4
MORE MORE
PUSH
CLOSE OPEN TO SET
LIMITS
LIMIT ADJUSTMENT
Learn
code
button
Radio
signal
indicator
Fig. 9-1
Fig. 10-1
Visor clip
Fig. 10-2
NEC
CLASS 2
PUSH
1
BUTTON
COM 2
NOTE:
SAFETY
USE ONLY WITH 3
BEAM
SERIES II CONTROLS
4
DO NOT
PUSH
LIMIT SET
5
UNLESS
DOOR IS
ATTACHED
6
LIMIT
SET
OPEN
CLOSE OPEN
FORCE
MORE MORE
CLOSE MORE
FORCE FORCE
RADIO
SIGNAL
CLOSE OPEN
LEARN
CODE
LIMIT ADJUSTMENT
U.S. Patent No. 5,243,784
5,221,869
PRO-MAX
Battery
cover
Battery
–
+
25