Main Limit Switch Settings - Genie GPS-IC Owner's Manual

6

MAIN LIMIT SWITCH SETTINGS

...
Door opens rapidly.
• Keep path clear.
• Position ladder to the side of power head so it
22
is clear of all moving parts of door and
operator.
Set door operator so minimum force is needed
to operate door.
Before starting main limit switch settings, LOCK
carriage onto rail assembly (See emergency
release tag).
1. Raise the door until the carriage engages with
the inner-slide/bullet.
2. Set "OPEN" limit switch (Fig 6-1).
• Locate limit set switch on back of power head.
• Push and hold limit set switch until door moves
to the fully open position.
– release the limit set switch.
– "OPEN" limit switch is set.
NOTE: If door stops and refuses to move up, adjust
"OPEN FORCE" (See Section 7-FORCE
ADJUSTMENT) and then repeat setting limit switch.
3. Set "CLOSE" limit switch (Fig. 6-1).
• Push and hold limit set switch until door contacts
the ground and stops.
– release limit set switch.
– "CLOSE" limit is set.
NOTE: If door stops and refuses to move down,
adjust "CLOSE FORCE" (See Section 7-FORCE
ADJUSTMENT) and then repeat setting limit switch.
NOTE: Do Not push the limit set switch again, your
limits are set. Slight adjustment may be needed later
(See Section 8-FINE LIMIT SWITCH ADJUSTMENTS).
WARNING
FOR HELP-1.800.354.3643 OR GENIECOMPANY.COM
1
2
NEC
CLASS 2
3
4
OPEN
MORE MORE
PUSH
CLOSE
CLOSE OPEN TO SET
LIMITS
LIMIT ADJUSTMENT
STEALTH
OR
CLASS 2
PUSH
BUTTON
COM
NOTE:
SAFETY
USE ONLY WITH
BEAM
SERIES II CONTROLS
DO NOT
PUSH
LIMIT SET
UNLESS
DOOR IS
ATTACHED
LIMIT
SET
OPEN
CLOSE OPEN
FORCE
MORE MORE
CLOSE
FORCE
RADIO
SIGNAL
CLOSE OPEN
LEARN
CODE
LIMIT ADJUSTMENT
U.S. Patent No. 5,243,784
5,221,869
PRO MAX
Fig. 6-1
PUSH
TO SET
LIMITS
PUSH
LIMIT SET
5
UNLESS
NEC
DOOR IS
1
ATTACHED
2
6
3
4
5
LIMIT
6
SET
MORE
OPEN
FORCE
FORCE
MORE
CLOSE
FORCE
FORCE