Other Printing Problems - Ricoh SP C261SFNw User Manual

Problem
Prints do not stack properly.
The printed paper is curled.
Printed envelopes come out creased. Check if the fusing unit levers are properly set. Lower the fusing

Other Printing Problems

Problem
The toner has run out and printing
has stopped.
• The paper being used may be damp. Use paper that has
been stored properly. See page 63 "Supported Paper".
• Select [Level 2: Medium] or [Level 3: Strong] in [Anti-
Humidity Level] under [System Settings]. Note that if you
select [Level 2: Medium] or [Level 3: Strong], the first
print takes longer than subsequent prints.
• Pull up the appropriate stop fence (forward fence for
A4/Letter, rear fence for Legal size prints). See page 17
"Guide to Components".
• Load the paper upside down in the paper tray.
• If the paper curl is severe, retrieve prints from the output
tray more frequently.
• The paper being used may be damp. Use paper that has
been stored properly.
• Select [Level 1: Weak], [Level 2: Medium] or [Level 3:
Strong] in [Anti-Humidity Level] under [System Settings].
Note that if you select [Level 2: Medium] or [Level 3:
Strong], the first print takes longer than subsequent prints.
• If you enable [Toner Saving] under [System Settings],
printing is generally less dense.
unit levers.
When the "Continue printing?" message appears on the
control panel, pressing [Yes] allows you to print a few more
pages, but the print quality of those pages may be lower.
Printer Problems
Solution
Solution
377