Ricoh SP C261SFNw User Manual page 350

10. Troubleshooting
Message
Replacement
Required:
Fusing Unit
Replacement
Required:
Paper Feed Roller
Replacement
Required:
Toner Cartridge (X)
Replacement
Required:
Transfer Roller
RX Communication
Error
Scan (NW)
Disconnected
Scan (USB)
Disconnected
Server Connection
Failed
Server Response
Error
SCXXX
348
Causes
The fusing unit is no longer
usable, and must be replaced.
The paper feed roller is no
longer usable, and must be
replaced.
The machine has run out of
toner.
The transfer roller is no longer
usable, and must be replaced.
A reception error occurred, and
the fax could not be received
correctly.
A scanned file could not be sent
because the Ethernet cable was
not connected properly.
The USB cable was
disconnected while scanning
from a computer.
A scanned file could not be sent
because the destination could
not be reached.
An error occurred in
communication with the server
before beginning transmission.
A fatal hardware error has
occurred, and the machine
cannot function.
Solutions
Contact your sales or service
representative.
Contact your sales or service
representative.
Replace the print cartridge. See page 315
"Replacing the Print Cartridge".
Contact your sales or service
representative.
If possible, contact the sender of the fax
and ask them to resend it.
Reconnect the Ethernet cable properly,
and then try the operation again.
Reconnect the USB cable properly, and
then try the operation again.
Confirm that the destination is registered
correctly, and then try the operation again.
Confirm that the destination is registered
correctly, and then try the operation again.
If the problem could not be solved, contact
the network administrator.
Contact your sales or service
representative.