TP-Link TL-WR941HP User Manual page 81

Select a schedule from the Schedule drop-down list or choose "Click Here To Add New
5.
Schedule".
6. In the Status field, select Enabled or Disabled to enable or disable your entry.
7. Click the Save button.
For example: If you desire to allow the host with MAC address 00-11-22-33-44-AA to access
www.tp-link.com only from 18:00 to 20:00 on Saturday and Sunday, and forbid other hosts in
the LAN to access the Internet, you should follow the settings below:
1. Click the menu Access Control on the left. Select Enable Internet Access Control and
choose "Allow the packets specified by any enabled access control policy to pass
through the router".
2. Click Setup Wizard button.
3. Add a new host with the Host Description is Host_1 and MAC Address is
00-11-22-33-44-AA, and click Next.
4. Add a new target with the Target Description is Target_1 and Domain Name is
www.tp-link.com, and click Next.
5. Add a new schedule with the Schedule Description is Schedule_1, Day is Sat and Sun,
Start Time is 1800 and Stop Time is 2000, and click Next.
6. Add a new rule with the Rule Description is Rule_1, Host is Host_1, Target is Target_1,
Schedule is Schedule_1, Status is Enabled, and click Finish.
Then you will go back to the Access Control Rule Management page and see the following list.
3.4.10.2. Host
Go to "Advanced→Access Control→Host", and then you can view and set a Host list in the
screen as shown in Figure 3-54. The host list is necessary for the Access Control Rule.
TL-WR941HP
Figure 3-53 Add Internet Access Control Entry
450Mbps High Power Wireless N Router
70