TP-Link TL-WR941HP User Manual page 5

Ukraine Limited
implementation
ATTENTION: Due to EU law, the country settings must be identical to the country where the
device is operating (important due to non-harmonised frequencies in the EU).
Canadian Compliance Statement
This device complies with Industry Canada license-exempt RSSs. Operation is subject to the
following two conditions:
1） This device may not cause interference, and
2） This device must accept any interference, including interference that may cause undesired
operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes :
1） l'appareil ne doit pas produire de brouillage;
2） l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, meme si le
brouillage est susceptible d'en compromettre le fonctionnement.
This radio transmitter (IC:8853A-WR941HP/Model:TL-WR941HP) has been approved by Industry
Canada to operate with the antenna types listed below with the maximum permissible gain
indicated. Antenna types not included in this list (Appendix C), having a gain greater than the
maximum gain indicated for that type, are strictly prohibited for use with this device.
Le présent é metteur radio (IC:8853A- WR941HP /Model: TL-WR941HP) a été approuvé par
Industrie Canada pour fonctionner avec les types d'antenne énumérés ci-dessous et ayant un
gain admissible maximal. Les types d'antenne non inclus dans cette liste (Annexe C), et dont le
gain est supérieur au gain maximal indiqué, sont strictement interdits pour l'exploitation de
l'é metteur.
Radiation Exposure Statement:
This equipment complies with IC radiation exposure limits set forth for an uncontrolled
2.2. Maximum mean e.i.r.p. density is 20 mW/MHz. Maximum
100 mW e.i.r.p. It is permitted to use SRD for outdoor
applications only for
information for automated
accounting systems or security systems.
2.3. Maximum mean e.i.r.p. density is 10 mW/MHz. Maximum
100 mW e.i.r.p. Indoor applications.
e.i.r.p. ≤100 mW with built-in antenna with amplification factor
up to 6 dBi.
purposes of gathering
monitoring and
telemetry
resources