Dhcp - TP-Link TL-WR941HP User Manual


Allow Guests To Access My Local Network - Click ON/OFF to enable or disable this
feature. If enabled, guests can communicate with hosts.

Wireless - Click ON/OFF to enable or disable your Guest network. If enabled, the wireless
stations will be able to access the Router, otherwise, wireless stations will not be able to
access the Router.

Network Name(SSID) - Create a name (up to 32 characters) for your Guest network. The
same Name(SSID) must be assigned to all wireless devices in your Guest Network.

Password - Create a password for your wireless network. The password must have a
minimum of 8 characters in length.
Click the Save button to save your settings.

5.3.5 DHCP

There are three submenus under the DHCP menu: DHCP Settings, DHCP Client List and
Address Reservation. Click any of them, and you will be able to configure the corresponding
function.
5.3.5.1. DHCP Settings
Go to "Setting→DHCP→DHCP Settings", and then you can configure the DHCP Server on the
page as shown below. The Router is set up by default as a DHCP (Dynamic Host Configuration
Protocol) server, which provides the TCP/IP configuration for all the PC(s) that are connected to
the Router in the LAN.
TL-WR941HP 450Mbps High Power Wireless N Router
Figure 5-16 Guest Network
150