TP-Link TL-WR941HP User Manual page 72


UDP-FLOOD Packets Threshold (5~3600) - The default value is 500. Enter a value
between 5 ~ 3600. When the current UPD-FLOOD Packets number is beyond the set value,
the router will startup the blocking function immediately.

Enable TCP-SYN-FLOOD Attack Filtering - Enable or Disable the TCP-SYN-FLOOD
Attack Filtering.

TCP-SYN-FLOOD Packets Threshold (5~3600) - The default value is 50. Enter a value
between 5 ~ 3600. When the current TCP-SYN-FLOOD Packets numbers is beyond the
set value, the router will startup the blocking function immediately.

Ignore Ping Packet From WAN Port - Enable or Disable Ignore Ping Packet From WAN
Port. The default setting is disabled. If enabled, the ping packet from the Internet cannot
access the router.

Forbid Ping Packet From LAN Port - Enable or Disable Forbid Ping Packet From LAN
Port. The default setting is disabled. If enabled, the ping packet from LAN cannot access
the router. This function can be used to defend against some viruses.
Click the Save button to save the settings.
Click the Blocked DoS Host List button to display the DoS host table by blocking.
3.4.8.3. Local Management
Go to "Advanced → Security → Local Management", and then you can configure the
management rule in the screen as shown below. The management feature allows you to deny
computers in LAN from accessing the router.
By default, the radio button "All the PCs on the LAN are allowed to access the router's
Web-Based Utility" is checked. If you want to allow PCs with specific MAC Addresses to
access the Setup page of the router's Web-Based Utility locally from inside the network, check
the radio button "Only the PCs listed can browse the built-in web pages to perform
Administrator tasks", and then enter each MAC Address in a separate field. The format for the
TL-WR941HP 450Mbps High Power Wireless N Router
Figure 3-43 Local Management
61