Kyocera ECOSYS P7240cdn Operation Manual page 215

Troubleshooting > Troubleshooting
Symptom
Part of the image is
periodically faint or shows
white lines.
Skewed-color printout.
Colors appear different than
you anticipated.
The previous image remains
and lightly printed.
The color toner is empty.
The machine is emitting
steam in the area around the
paper ejection slot.
Checkpoints
―
―
―
―
―
Do you want to continue printing in black
and white?
Check the room temperature to see if it
is low, or if damp paper was used.
Corrective Actions
Open and then close the rear cover.
ECOSYS P6235cdn: Select the [Menu]
key > [Adjust/Maint.] > [Service
Setting] > [MC] and decrease the
adjustment value. Decrease the
adjustment value 1 level at a time from
the current value. If there is no
improvement after the value is
decreased by 1 level, decrease by 1
level again. If there is still no
improvement, return the setting to the
original value.
Run [ColorCalibration].
Run [Color Regist.].
When printing from a computer
Adjust the color using the printer driver.
ECOSYS P6235cdn: Select the [Menu]
key > [Adjust/Maint.] > [Service
Setting] > [MC] and increase the
adjustment value. Increase the
adjustment value 1 level at a time from
the current value. If there is no
improvement after the value is
increased by 1 level, increase by 1 level
again. If there is still no improvement,
return the setting to the original value.
If the black toner is remained, the
machine continues printing in black and
white by selecting [Print in B & W] of
[ColorToner Empty].
Depending on the printing environment
and the paper's condition, the heat
generated during printing will cause the
moisture in the paper to evaporate, and
the steam emitted may look like smoke.
This is not a problem, and you can
continue printing. If the steam concerns
you, raise the room temperature, or
replace the paper with a newer, dryer
paper.
10-12
Reference
Page
page 2-2
―
page 10-20
page 10-20
―
―
page 8-27
―