Table of Contents
Advertisement
4.1.4
Changing the parameter setting value
Changing example Change the Pr. 1 Maximum frequency .
1.
Screen at power-ON
The monitor display appears.
2.
Press
to choose the PU operation
mode.
3.
Press
setting mode.
4.
5.
Press
to read the present set value.
"
"(initial value) appears.
6.
Turn
to change it to the set
value "
7.
Press
to set.
to
appears. ...... Write disable error
appears. ...... Write error during operation
appears. ...... Calibration error
appears. ..... Mode designation error
For details refer to page 334.
REMARKS
⋅ The number of digits displayed on the operation panel (FR-DU07) is four. Only the upper four digits of values can be displayed
and set. If the values to be displayed have five digits or more including decimal places, the fifth or later numerals cannot be
displayed nor set.
(Example) When Pr.1
When 60Hz is set, 60.00 is displayed.
When 120Hz is set, 120.0 is displayed. The second decimal places cannot be displayed nor set.
POINT
When Pr. 77 Parameter write selection = "0 (initial setting)," the parameter setting change is only available while the inverter is
stopped under the PU operation mode. To enable the parameter setting change while the inverter is running or under the
operation mode other than PU operation mode, change the Pr. 77 setting.
4.1.5
Displaying the set frequency
During PU operation mode and External/PU combined operation mode (Pr. 79 = "3"), push the setting dial (
display the set frequency currently set.
Operation
to choose the parameter
Pr. 1) appears.
".
· Turn
to read another parameter.
· Press
to show the setting again.
· Press
twice to show the next parameter.
· Press
twice to return the monitor to frequency monitor.
are displayed ... Why?
Operation panel (FR-DU07)
Display
PU indicator is lit.
The parameter
number read
previously appears.
Flicker ··· Parameter setting complete!!
4
) to
61
Advertisement
Table of Contents
