Table of Contents
Advertisement
Setting of FR-PU07-01
4.24.1 PID display bias/gain setting menu
The parameters, which need to be set first when FR-PU07-01 is connected, are displayed as a list. The bias and
gain for the PID display (Pr. 934 and Pr. 935 ) and setting for Pr. 999 Automatic parameter setting can be set in these
simple steps.
Pressing
while the FR-PU07-01 is in the monitor mode brings up the dedicated menu screen.
Pr. 999 is displayed at the first turn ON of the inverter, or at the first turn ON after parameter clear. After
Pr. 999 is set, Pr. 934 and Pr. 935 are displayed on the dedicated parameter menu.
(This function is valid under PID control. If
parameter setting mode.)
Display of the dedicated parameter menu differs depending on Pr. 999 setting and PID control condition.
Condition
Pr.999 setting
Never set before
1 (normal PID)
2 (extended PID)
REMARKS
The parameters, which are displayed in the dedicated parameter menu, can be always read regardless of the Pr. 160 setting. For
writing, the same restriction as for the normal parameters is applied.
320
PIDset
0. 0
P S I
- - - STOP HAND
Monitor mode
934 PID bi as
935 PID gai n
PrSET:PrSET
Dedicated menu
934 PID bi as
935 PID gai n
PrSET:PrSET
Dedicated menu
Example when setting value "2" is set once in Pr. 999
When PID control is unavailable
(Pr. 128 < 50, and Pr. 753 < 50, and
X14 signal not assigned)
Pr. 999
No display
Pr. 934, Pr. 935
is pressed while PID control is invalid, the monitor goes into the
SETTING MODE
0~ 9: S e r P r . N o.
S el e ct O per
Parameter setting mode
to
SETTING MODE
P r . N o . .
to
13 3
< R E A D >
Parameter setting mode
934 P I D bi a s
9 999
S et <W R I TE >
E x t< R E A D >
Parameter setting screen (Pr.934)
Dedicated parameter menu
When PID control is available
(Pr. 128
≥
50, or Pr. 753
≥
X14 signal assigned)
Pr. 999, Pr. 934, Pr. 935
Pr. 934, Pr. 935
Pr. 934, Pr. 935
50, or
Advertisement
Table of Contents
