Oce Eco Solvent CS9060 User Manual page 98

4.8.4 Cutting media
Caution
•
When printing is finished, the media guide is at high temperature. Wait until the media guide
cools off.
Step 1 : Verify the following regarding the operational condition of the product.
• The operation panel displays: "Ready to print".
Step 2 : If the roll media cut position is changed, refer to "Feeding media" and advance the roll media to
the desired cut position.
Step 3 : Open the front cover.
1
Step 4 : Place a razor blade on the media cut groove on the media guide, and cut the roll media.
Caution
•
Pay attention to the following points when you cut roll media.
When you hold media, do not place your finger on the media cut groove.
o
Move the razor blade along the media cut groove.
o
1
•
Cutting roll media is complete.
Notes
•
When loading the new roll media, cut the front edge of the media if it is not straight.
No. Name
1 Front Cover
2 3
No. Name
1 Media guide
2 Media cut groove
3 Razor blade
98
User's Guide Océ CS9060 printer
Chapter 4 : Handling the printer
AP-75770 – Rev 1.1 -19/11/2007,