Oce Eco Solvent CS9060 User Manual page 86

4.7.1.11 Dryer menu
Notes
•
Temperature to be set for the after Heater varies depending on the media which is used. For
recommended temperature settings of the after heater, refer to the "Recommended media list".
Setup Item
After Heater
4.7.1.12 Standby Heating menu
Set up whether each heater is preheated (idle heat) while in standby mode.
Setup Item Setting Value
StandbyHeating
4.7.1.13 Vacuum Fan menu
Setup Item Setting Value
Vacuum Fan
Setting Value
OFF / <30° C> to 50° C
—
OFF Idle heat is not performed.
<ON> Set up whether each heater is preheated while in standby mode.
•
[Enter] key: Save the setting and shift to the previous
hierarchy.
•
—
[Cancel] key: Cancel the setting and shift to the previous
hierarchy.
► User media menu
Low Set when using soft media
<High> Set when regular media is used.
•
[Enter] key: Save the setting and shift to the previous
hierarchy.
— •
[Cancel] key: Cancel the setting and shift to the previous
hierarchy.
► User media menu
User's Guide Océ CS9060 printer
Chapter 4 : Handling the printer
Description
Set up the after Heater temperature.
2
1. Roll media
2. Dryer- After heater
3. Print head
•
[Enter] key: Save the setting and shift to the
previous hierarchy.
•
[Cancel] key: Cancel the setting and shift to
the previous hierarchy.
► User media menu
Description
Description
86 AP-75770 – Rev 1.1 -19/11/2007,
3
1