Table of Contents
Advertisement
installation
Log C in position
6. Install Log D onto the 2 pins on the burner in
locations shown below.
D
7. Install Log E (Y shaped Log) onto the pin on Log
B--set the other end of Log E on the burner.
E
8. Install Log F across Log C as shown, Log F
will rest in a flat spot on Log C.
26
C
Log D install
Log E install
F
C
Log F install
F
Log F in position
9. Install Log G--top end sits in the notch at
the top of Log F and the bottom end of
Log G rests against the bracket on the
burner as shown.
G
Notch
F
Log G install
G
Log G onto bracket
10. Test fire to ensure proper light off (make
sure flame flows smoothly from one end
of burner to the other. If there is any flame
hesitation, check that area for any blockage
of the burner port.
Completed Install
Bracket
FG39-2 Freestanding Gas Stove
Advertisement
Table of Contents
