Ricoh D649 Field Service Manual page 95

G3 Burst error threshold
0
0: Low 1: High
Acceptable total error line ratio
1
0: 5% 1: 10%
Treatment of pages received with errors
during G3 reception
2
0: Deleted from memory without printing
1: Printed
Hang-up decision when a negative code
(RTN or PIN) is received during G3
3
immediate transmission
0: No hang-up, 1: Hang-up
4-7 Not used
No Function
Maximum number of page
0-7 retransmissions in a G3 memory
transmission
Communication Switch 04 - Not used (do not change the settings)
Communication Switch 05 - Not used (do not change the settings)
Communication Switch 03 (SP No. 1-104-004)
00 - FF (Hex) times.
This setting is not used if ECM is switched on.
Default setting - 03(H)
If there are more consecutive error lines in the
received page than the threshold, the machine
will send a negative response. The Low and High
threshold values depend on the sub-scan
resolution, and are as follows.
100 dpi 6(L) 12(H)
200 dpi 12(L) 24(H)
300 dpi 18(L) 36(H)
400 dpi 24(L) 48(H)
If the error line ratio for a page exceeds the
acceptable ratio, RTN will be sent to the other
end.
0: Pages received with errors are not printed.
0: The next page will be sent even if RTN or PIN
is received.
1: The machine will send DCN and hang up if it
receives RTN or PIN.
This bit is ignored for memory transmissions or if
ECM is being used.
Do not change the settings.
Comments
Bit Switches
93