Ricoh D649 Field Service Manual page 70

4. Service Tables
Priority given to various types of
remote terminal ID when printing
reports
7 0: RTI > CSI > Dial label > Tel.
number
1: Dial label > Tel. number > RTI >
CSI
No
Automatic port selection
0
0: Disabled, 1: Enabled
1-3 Not used
Dialing on the ten-key pad when the
external telephone is off-hook
4
0: Disabled 1: Enabled
On hook dial
5
0: Disabled 1: Enabled
6-7 Not used
System Switch 0B - Not used (Do not change the factory settings.)
System Switch 0C - Not used (Do not change the factory settings.)
System Switch 0D - Not used (Do not change the factory settings.)
No
68
This bit determines which set of priorities the machine
uses when listing remote terminal names on reports.
Dial Label: The name stored, by the user, for the
Quick/Speed Dial number.
System Switch 0A (SP No. 1-101-011)
Function
When "1" is selected, a suitable port is automatically
selected if the selected port is not used.
NOTE: This bit is useful if all communication lines at a
customer site are not same quality.
Do not change these settings.
0: Prevents dialing from the ten-key pad while the
external telephone is off-hook. Use this setting when
the external telephone is not by the machine, or if a
wireless telephone is connected as an external
telephone.
1: The user can dial on the machine's ten-key pad
when the handset is off-hook.
0: On hook dial is disabled.
Do not change the factory settings
System Switch 0E (SP No. 1-101-015)
Function
Comments
Comments