Ricoh D649 Field Service Manual page 77

Action when authorized reception is
enabled but authorized RTIs/CSIs
are not yet programmed
4
0: Faxes can be received if the
sender has an RTI or CSI
1: All fax reception is disabled
5-7 Not used
No Function
0 Not used
Report printout after an original jam
during SAF storage or if the SAF
memory fills up
1
0: Enabled
1: Disabled
2 Not used
Received fax print start timing
(G3 reception)
3
0: After receiving each page
1: After receiving all pages
4-6 Not used
Action when a fax SC has occurred
7 0: Automatic reset
1: Fax unit stops
If authorized reception is enabled but the user has
stored no acceptable sender RTIs or CSIs, the
machine will not be able to receive any fax messages.
If the customer wishes to receive messages from any
sender that includes an RTI or CSI, and to block
messages from senders that do not include an RTI or
CSI, change this bit to "0", then enable Authorized
Reception.
Otherwise, keep this bit at "1 (default setting)".
Do not change the settings
System Switch 1F (SP No. 1-101-032)
Do not change the settings.
0: When an original jams, or the SAF memory
overflows during scanning, a report will be printed.
Change this bit to "1" if the customer does not want to
have a report in these cases.
Memory tx – Memory storage report
Parallel memory tx – Transmission result report
Do not change the settings.
0: The machine prints each page immediately after
the machine receives it.
1: The machine prints the complete message after the
machine receives all the pages in the memory.
Do not change the factory settings.
0: When the fax unit detects a fax SC code other than
SC1201 and SC1207, the fax unit automatically
resets itself.
1: When the fax unit detects any fax SC code, the fax
unit stops.
Cross Reference
Fax SC codes - See "Troubleshooting"
Bit Switches
Comments
75