Table of Contents
Advertisement
7. INSTALL WHIRLPOOL
A. WHIRLPOOL SET-IN
CAUTION: Risk of product damage. Do not use
the piping or pump for structural support or
positioning.
Slide new bath into position. Insert tailpiece into trap.
Shim under whirlpool feet as necessary with metal shims
to level. Bath must be level and resting on all four feet.
Check for level along the top of the side of the whirlpool
and across the drain end. Whirlpool may have to be
moved in and out of recess area until shimmed properly
if feet are not accessible from back or side.
B. INSTALL PLUMBING
CAUTION: Risk of damage to whirlpool
bottom and subfloor. Ensure watertight seal on
bath drain connections.
1.
When whirlpool is securely positioned, connect
drain into trap. An access panel will simplify future
maintenance.
2.
Install the faucet valving and spout tee. If faucets
are deck-mounted, the deck must be finished
before handle trim and spout can be installed. Open
hot and cold valves and check all supply
connections for leaks.
3.
Run water in whirlpool and check drain connection
for leaks.
8. INSTALL GRIP RAILS
Refer to Installation Instructions packed with the K-9621
grip rail kit when installing grip rails.
CA
111835-
(1093)
Metal Shims
10
Metal Shim
Connect Here
Kohler Co., Kohler WI
Advertisement
Table of Contents
