Table of Contents
Advertisement
11. INSTALL THE WHIRLPOOL
A. WHIRLPOOL SET-IN
Choose the installation option (Step 1., 2., or 3.
below) that applies to your particular installation. Follow
the appropriate instructions.
If the subfloor is not level, some shimming of the bath will
be necessary.
NOTICE: Do not hang the whirlpool by the rim.
1.
Option For Sunken Installation: Set the bath into
the sunken installation. Make sure the unit is level
and resting on all support feet. Insert the drain
tailpiece into the trap. Apply a bead of silicone
sealant under the rim of the unit.
CAUTION: Risk of product damage. Do not
hang the unit by the rim.
2.
Option For Using Gypsum: Spread a 2" thick
layer of gypsum cement on the floor where the bath
is to be set. This will help secure, level, and support
the unit. Set the bath into position. Clear any excess
cement from the vicinity of the pump.
NOTE: Support bracket must sit flat on the floor.
Insert the drain tailpiece into the trap. Make sure the
bath is level and resting on all support feet.
3.
Option For Using Construction Adhesive:
Apply a generous amount of construction adhesive
to the bottom of the support feet. Set the bath in the
desired location, and level it.
Insert the drain tailpiece into the trap. Make sure the
bath is level and resting on all support feet.
EA
113867-2-
(-)
Whirlpool Rim
14
1/16" Gap Between
Whirlpool Rim and
Framing
Apply Construction Adhesive
to Support Feet
Kohler Co., Kohler WI
Advertisement
Table of Contents
