Related Manuals for Kohler Maestro K-842-V-AB
Summary of Contents for Kohler Maestro K-842-V-AB
- Page 1 Maestro Whirlpool Baths: K-842-V-AB K-845-V-AB K-842-JA-AA K-845-JA-AA Copyright E1993 Kohler Co. 111835- (1093)
-
Page 2: Important Safety Instructions
Use this unit only for its intended use as denoted in this suction fitting. manual. DO NOT use attachments not recommended by the Kohler Co. Never drop or insert any object into any opening. DANGER: To reduce the risk of injury, do not permit children to use this unit unless they are closely supervised at all times. -
Page 3: Table Of Contents
Follow the sections that pertain Kohler Co. reserves the right to make changes in to your particular installation. This will aid you in avoiding product characteristics, packaging, or availability at any the unnecessary expense associated with improper time without notice. -
Page 4: Roughing-In: K-842-V-Ab, K-845-V-Ab
64-1/2” x 30-1/2” Minimum access: Pump/control box 20” W x 15” H panel required 16” FIELD WIRING COMPARTMENT 32” PUMP 9-1/4” 66” PUMP/CONTROL ACCESS 3/4” 3-1/4” 18-1/4” 2-7/8” 1/4” 3” 1-1/2” I.P.S. THR’D 1-1/2” O.D. 1.75>132 Kohler Co., Kohler WI 111835- (1093) -
Page 5: Product Notices
WARNING: Risk of injury or property damage. Kohler Co. shall not be liable under its warranty or Please read all instructions thoroughly before otherwise for personal injury or damage caused by beginning installation, including the following any such unauthorized modification. -
Page 6: Product Requirements
K-842-JA-AA, K-845-JA-AA: The installation must have an Earth Leakage Circuit Breaker (ELCB). This will provide additional protection against line-to-ground shock hazard. A 230 V, 50 Hz separate circuit that provides15 A of continuous service is required. Kohler Co., Kohler WI 111835- (1093) -
Page 7: Installation Requirements
4. Cap supplies and check for leaks. For replacement installations: Remove old bath, remove old wall material and remove old floor covering from area. Remove old plumbing which does not conform to roughing-in requirements. 111835- (1093) Kohler Co., Kohler WI... -
Page 8: Site Requirements
Bath can be installed as a corner, recess or sunken installation. Possible studding arrangements are illustrated in 1. through 3. below; modifications may be needed for other types of construction. Corner Installation: Suggested stud construction is illustrated. Kohler Co., Kohler WI 111835- (1093) -
Page 9: Plumbing Preparation
Instructions packed with the tiling-in bead. B. PARTIALLY INSTALL BATH DRAIN Install drain bath/whirlpool according manufacturer’s instructions. C. PROTECT BATH UNIT Place a drop cloth or similar material in bath/whirlpool bottom. Be careful not to scratch product. 111835- (1093) Kohler Co., Kohler WI... -
Page 10: Install Whirlpool
Run water in whirlpool and check drain connection for leaks. 8. INSTALL GRIP RAILS Refer to Installation Instructions packed with the K-9621 grip rail kit when installing grip rails. Kohler Co., Kohler WI 111835- (1093) -
Page 11: Field Wire Electronics
Do not use a grounding adapter. Your Kohler Whirlpool bath is equipped with a cord and plug. All wiring of the pump and control has been completed at the factory. A licensed electrician must install a GFCI protected, 120 Volt, 15 Amp, grounded outlet. -
Page 12: Connect Control Box - 230 V, 50 Hz
Tape and mud drywall...seal drywall and joints under 2 x 4 Studding bath rim. Install finished wall material to subwall. Seal joints between the whirlpool rim and finished wall using Vinyl Tiling-In Bead silicone sealant. Bath Rim Kohler Co., Kohler WI 111835- (1093) -
Page 13: Complete Installation
Plaster can be removed by scraping with a wood edge. Do not use metal scrapers, wire brushes, or other metal tools. One of the powder-type detergents may be used on a damp cloth to provide mild abrasive action to the residual plaster. 111835- (1093) Kohler Co., Kohler WI... -
Page 14: Confirm Proper Operation
A built-in timer automatically stops the motor after Add air to whirl- Reduce 20 minutes of operation. pool action, rotate flange counter- clockwise. To reduce air, turn clockwise. Shut off whirlpool. Restart whirlpool after 20 minute cycle is com- plete. Kohler Co., Kohler WI 111835- (1093) -
Page 15: Troubleshoot Whirlpool System
C. TROUBLESHOOT WHIRLPOOL SYSTEM This troubleshooting guide is for general aid only. A Kohler Authorized Service Representative or a qualified electrician should correct all electrical problems. For warranty service, contact your dealer or wholesale distributor. SYMPTOMS PROBABLE CAUSES RECOMMENDED ACTION 1. - Page 16 111835- (1093) Kohler Co., Kohler WI...