Installing The Front Panel Board; Removing The Front Panel Module; Installing Non-Hot Swap Drives - HP server rx4610 Service Manual

Chapter 6
7. Replace the Front Bezel.

Installing the Front Panel Board

The Front Panel Board displays server information. The module is attached to the front of the Hard Disk
Bay, which must first be removed to gain access to the Front Panel Board.

Removing the Front Panel Module

To remove the Front Panel module, complete the following procedure:
1. Turn off the system by using the power on/off switch on the front of the chassis and remove
both AC power cords.
2. Remove the Hard Disk Bay from the chassis as described in "Removing the Hard Disk Bay"
earlier in this chapter.
3. Disconnect the cable to the Front Panel Board that is attached to the front of the Hard Disk Bay
by squeezing the cable retention levers together. You do not have to remove the rear part of
the cable.
4. Remove the two screws securing the Front Panel Board to the front panel mounting on the Hard
Disk Bay. These screws are located on the inside of the Front Panel Board.
5. Remove the Front Panel Board from the Hard Disk Bay assembly and place it on an ESD
protected work surface.
2. Remove the two screws.
Installing the Front Panel Board
To install the new Front Panel Board, complete the following steps:
1. Using two Phillips screws, secure the new Front Panel Board to the Hard Disk Bay.
2. Connect the front part of the Front Panel Board data cable to the connector on the new Front
Panel Board.
3. Install the Hard Disk Bay into the chassis as described in "Installing the Hard Disk Bay" above.

Installing Non-Hot Swap Drives

The HP Server supports a slimline IDE diskette drive for 1.44 MB and 120 MB media and a DVD drive. Both
drives are part of the standard configuration and mount directly above the power bays on the front of the
chassis. The drives are mounted on removable trays that facilitate system assembly and service. The
server must be powered down to install these drives.
Figure 33. The Front Panel Board
1. Disconnect the cable.
Replacing Parts
99