Four-Bay Lff Non-Hot-Plug Drive Backplane - HP ProLiant DL160 Gen9 Maintenance And Service Manual

Remove all hot-plug hard drives.
5.
Disconnect all cables connected to the drive backplane.
6.
Remove the hot-plug drive backplane.
7.
To replace the component, reverse the removal procedure.

Four-bay LFF non-hot-plug drive backplane

To remove the component:
Power down the server (on page 26).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Do one of the following:
3.
Extend the server from the rack (on page 28).
o
Remove the server from the rack (on page 29).
o
Remove the access panel
4.
Remove all non-hot plug drives.
5.
page 29)
Disconnect all cables connected to the drive backplane.
6.
("Access panel" on page 30).
("Non-hot-plug drive" on page 27, "Non-hot-plug drive
Removal and replacement procedures 32
carrier" on