Toro Pro Sneak 360 Operator's Manual page 9

2
1
1. Port A on the motor
2. Port B on the motor
2. Route the other 114.3 cm (45 inch) hose from port B
on the motor to port B on the hydra-borer-control
valve (Figure 14 and
3. Torque the hose ends to 73 to 89 N-m (54 to 66 ft-lb).
Installing the Hoses on a Machine
without the Trencher Attachment
Installed
Use this procedure if you have a machine that does not have
a trencher attached. If you have a machine has trencher
attached, go to Installing the Hoses on a Machine with the
Trencher Attachment Installed (page
Current hose routing
1. Hydraulic pump
2. Hose A (currently installed
on the machine)
3
g021980
Figure 15
3. Port A on the
hydra-borer-control valve
4. Port B on the
hydra-borer-control valve
Figure 15).
10).
2
1
3
Figure 16
3. Plow-control valve
1. Disconnect hose A from the hydraulic pump
16), add the hose connector, and connect hose B to the
4
other end of the connector
1. Hose connector
2. Hydra-borer-control valve
3. Hose A
2. Connect hose B (14 3/4 inches) to the 90-degree fitting
(Out port) on the control valve
17).
3. Torque the hose ends to 73 to 89 N-m (54 to 66 ft-lb).
4. Connect hose C (36 inches) to the straight fitting (In
port) on the control valve
pump (where Hose A was previously installed
16); refer to
1
g021981
1. Hydra-borer-control valve
2. Hydraulic pump
5. Torque the hose ends to 73 to 89 N-m (54 to 66 ft-lb).
9
(Figure 17).
2
3
1
4
5
Figure 17
4. Plow-control valve
5. Hose B (14 3/4 inches)
(Figure 14
(Figure 14) to the hydraulic
Figure 18).
3
Figure 18
3. Hose C (36 inches)
(Figure
g021983
and Figure
(Figure
2
g021984