Toro Pro Sneak 360 Operator's Manual page 6

2
Installing the Control Valve
and Handle (Pro Sneak 360)
Parts needed for this procedure:
1 Bracket
1 Control valve
1 90-degree, elbow fitting
2 45-degree, elbow fitting
1 Straight fitting
2 Bolt (3/8 x 1 inch)
4 Flat washer (3/8 inch)
2 Nut (3/8 inch)
1 Bolt (5/16 x 2-1/2 inch)
1 Bolt (5/16 x 2-1/4 inch)
2 Flat washer (0.344 inch)
2 Locknut (5/16 inch)
1 Clevis pin
1
Cotter pin
1 Control lever
1 Link assembly
1 Snap clip
Procedure
1. Install the fittings as shown in
2. Torque the fittings to 104 to 127 N-m (77 to 94 ft-lb).
3. Install the bracket and secure with the 2 nuts (3/8
inch), the 2 washers (3/8 inch), and the 2 bolts (3/8
inch) (Figure 8); torque to 38 to 43 N-m (28 to 32 ft-lb).
g021926
1. Nut (3/8 inch)
2. Flat washer (3/8 inch)
4. Install the control valve onto the bracket and secure
with the 2 bolts (5/16 x 2-1/4 inch and 5/16 x 2-1/2
inch), the 2 flat washers (0.344 inch) and the 2 locknuts
(5/16 inch) (Figure
to 225 in-lb).
6
Figure 7.
g021925
Figure 7
Figure 8
3. Bolt (3/8 inch)
9); torque to 20 to 25 N-m (175
1
2
3