Toro Pro Sneak 360 Operator's Manual page 12

Installing the Hoses on a Machine with
the Trencher Attachment Installed
Use this procedure if you have a machine that has a trencher
attached. If you have a machine that does not have a trencher
attached, go to Installing the Hoses on a Machine without the
Trencher Attachment Installed (page
1. Remove the short hose coming from the trencher
valve that is connected to the long hose leading to the
plow-cylinder valve
The short hose is not needed for this installation. The
hose can be discarded or kept for future use.
1 2
4
3
Figure 25
1. Short hose coming from
the trencher valve.
2. Trencher valve
3. Long hose coming from
the plow-cylinder valve
2. Connect the long hose coming from the plow-cylinder
valve to the inside fitting on the hydra-borer valve as
shown in Figure 25.
3. Torque to 81 N-m (60 ft-lb).
4. Connect a hydraulic tube from the open port on the
trencher valve to the hydra-borer valve (Port P) as
shown in Figure 26.
11).
(Figure 25).
3 4
5
4. Plow-cylinder valve
5. Hydra-borer valve
5. Torque to 81 N-m (60 ft-lb).
6. Remove the cap on the tube coming from the trencher
valve to the tube line
3
2
1
g02591 1
1. Radiator tube line
2. Cap
3. Trencher valve
7. Connect a hydraulic tube from the hydra-borer valve
(Port T) to the trencher tube as shown in
8. Torque to 81 N-m (60 ft-lb)
12
Figure 26
(Figure 27).
5
4
Figure 27
4. Hydraulic tube
5. Hydra-borer valve
Figure
g025912
g025910
27. .