Toro Pro Sneak 360 Operator's Manual page 7

Figure 9
1. Bolt (2-1/4 inch)
2. Bolt (2-1/2 inch)
3. Washer (0.344 inch)
5. Place the hydra-borer-control lever between the guide
on the bracket attached to the machine so that the
holes line up. Secure the control lever with the link
assembly and snap clip
Figure 10
1. Cotter pin
2. Clevis pin
6. Secure the upper hole of the control lever with the
clevis pin and the cotter pin
1
g021927
4. Bracket
5. Control valve
6. Locknut (5/16 inch)
(Figure 10).
1
2
3
4
g021928
3. Link assembly
4. Snap clip
(Figure 10).
3
Installing the Control Valve
2
and Handle (Pro Sneak 365)
3
Parts needed for this procedure:
4
1 Bracket
1 Control valve
2 45-degree, elbow fitting
5
3 Straight fitting
6
3 Bolt (1 1/4 inch)
3 Nut
1 Handle assembly
Procedure
1. Attach the bracket to the valve using the 3 bolts and 3
nuts shown in
2. Attach the fittings to the valve as shown in
and torque to 104 to 127 N-m (77 to 94 ft-lb).
7
Figure 11.
g025904
Figure 11
Figure 12