Toro Pro Sneak 360 Operator's Manual page 8

1
2
Figure 12
1. 45-degree fitting (2)
3. Remove the bolts securing the left panel to the machine.
4. Using the left panel bolts, install the valve assembly to
the machine (refer to
Figure 13
g025905
2. Straight fitting (3)
Figure 13).
A
4
Installing the Hoses
(Pro Sneak 360)
Parts needed for this procedure:
2 Hose, 114.3 cm (45 inches)
1 Hose, 91.44 cm (36 inches)
1 Hose, 37.44 cm (14 3/4 inches)
1 Hose connector
Installing the Hoses on Machines with
or without the Trencher Attachment
Installed
B
1
g025906
1. 45-degree fitting (Port B)
(45-inch hose from the
Motor)
2. 90-degree fitting (Out port)
(Hose B 14 3/4-inch hose
to the Plow Valve)
1. Route a 114.3 cm (45 inch) hose from port A on the
motor to port A on the hydra-borer-control valve
(Figure
Note: Route the hoses under the frame.
8
Figure 14
Control Valve Views
3. 45-degree fitting (Port A)
(45-inch hose from Motor)
4. Straight fitting (In Port)
(Hose C / 36-inch hose)
15).
3