Toro Pro Sneak 360 Operator's Manual page 11

1. Connect the 2 45-degree adapter fittings onto the
middle port of the control valve
to 81 N-m (60 ft-lb).
1
1. Hydra-borer motor
2. Bolt
3. R-clamp
2. Route the 2 hoses (95 cm) from the hydra-borer-control
valve to the hydra-borer motor as shown in
Note: Route the hoses under the frame.
3. Torque the hose ends to 73 to 89 N-m (54 to 66 ft-lb).
4. Secure the hoses with the r-clamps, bolts, and nuts.
Installing the Hoses on a Machine
without the Trencher Attachment
Installed
Use this procedure if you have a machine that does not have
a trencher attached. If you have a machine equipped with a
trencher attachment, go to
with the Trencher Attachment Installed (page
1. Disconnect the hose that is installed on the front
section of the hydraulic pump and connect it to the
hydra-borer-control valve as shown in
(Figure 22); torque
2
3 4 5 6
Figure 22
4. Nut
5. 45-degree adapter fittings
6. Hydra-borer-control valve
Figure
Installing the Hoses on a Machine
12).
Figure
A
g025907
B
22.
2. Torque the hose end to 81 N-m (60 ft-lb).
3. Connect the 51 cm hose from the open fitting on the
hydraulic pump to the hydra-borer-control valve (Port
B) as shown in
4. Torque to 81 N-m (60 ft-lb).
5. Remove the cap on the radiator tube line
23; box A.
2
1
1. Radiator tube line
2. Cap
6. Connect a hydraulic tube from the hydra-borer-control
valve (Port T) to the radiator tube line
7. Torque to 81 N-m (60 ft-lb).
11
Figure 23
Figure 23; box B.
4
3
Figure 24
3. 45-degree adapter
4. Plow-cylinder valve
(Figure
g025908
(Figure 24).
g025909
24).