Toro Pro Sneak 360 Operator's Manual page 10

Installing the Hoses on a Machine with
the Trencher Attachment Installed
Use this procedure if you have a machine that has a trencher
attached. If you have a machine that does not have a trencher
attached, go to Installing the Hoses on a Machine without the
Trencher Attachment Installed (page
Figure 19
Current hose routing on a machine with a trencher installed.
1. Hose E (trencher hose)
2. Hydraulic pump
3. Hose A
1. Disconnect hose A from hose D, leaving the hose
connector attached to hose A
2. Connect hose B (14 3/4 inches) to the hose connector
attached to hose A.
3. Connect the other end of hose B to the 90-degree
fitting (Out port) on the hydra-borer-control valve
(Figure 14 and Figure
1
Figure 20
1. Hose connector
2. Hydra-borer-control valve
3. Hose A
4. Add a hose connector to the end of hose D.
9).
4. Plow-control valve
5. Hose D (trencher hose)
6. Hose connector
(Figure 19).
20).
2
3
4
g021983
5
4. Plow-control valve
5. Hose B (14 3/4 inches)
5. Route hose C (36 inches) from the straight fitting (In
Port) on the hydra-borer control valve
the hose connector on hose D
2
1
g021985
1. Hose C (36 inches)
2. Hydra-borer-control valve
3. Hose connector
6. Torque the hose ends to 73 to 89 N-m (54 to 66 ft-lb).
5
Installing the Hoses
(Pro Sneak 365)
Parts needed for this procedure:
1 Hose, 51 cm (20 inches)
2
Hose, 95 cm (38 inches)
3 Hydraulic tube
1 90 degree adapter fitting
2 45 degree adapter fitting
2 R-clamps
2 Bolts
2 Nuts
Installing the Hoses to the Hydra Borer
Motor
Use a proper container to catch hydraulic fluid that will come
from disconnected hoses.
10
(Figure
(Figure 21).
4 5
3
Figure 21
4. Hose D
5. Trencher-control valve
14) to