Table of Contents
Advertisement
Safety information
2.4 Safe handling
Danger due to live stationary parts, moving or rotating parts
Contact with the parts mentioned can result in death, serious physical injury or damage to
property.
• Observe the instructions regarding installation and operation.
• Always take protective measures before touching any components.
• Do not remove any covers.
Risk of burns due to hot component surfaces
Certain components (e.g. the heat sink and reactor) can become very hot during operation.
These components can remain hot for a long time after operation. Severe skin injuries (burns)
can result when coming into contact with these components.
• After the device has been shut down, do not touch any hot components.
Risk of burns due to hot anti-condensation heating surface
When the temperature control limit value is reached the anti-condensation heating is switched
on. Once activated, the anti-condensation heating can generate a great deal of heat. Contact
can result in serious injury, such as skin burns.
• Ensure that the anti-condensation heating cannot be touched.
• Ensure that the anti-condensation heating is switched off before carrying out any repair or
maintenance work.
Risk of injury at places that are difficult to access
If you do not use appropriate protective equipment when working in places that are difficult to
access you are at risk of injury. For example, sharp edges and splinters can cause injuries to the
head and skin. If you carry out work in the upper section using unsuitable ladders or similar, you
can fall and injure yourself.
• Use appropriate protective equipment, especially a hard hat and gloves.
• Use suitable steps or ladders when working in the upper area.
Eye and skin injuries caused by deionized water
Deionized water is harmful to eyes and skin and can damage surfaces.
• Therefore, use appropriate protective clothing when you carry out any work on the drive.
However, if your eyes or skin do come into contact with deionized water, rinse the affected
area thoroughly with tap water as soon as possible.
• If deionized water leaks out, eliminate the source of the problem and remove the liquid from
the surfaces affected.
• Please refer to the EU safety data sheet of the coolant manufacturer.
14
3rd Party LCI Control Upgrade
Operating Instructions, 02/2022, A5E31872818
Advertisement
Table of Contents
