Adjust Tote Guides; Loading The Tote - Graco SaniForce STU Operation

Operation
Adjust Tote Tote Guides Guides
Adjust Adjust Tote Guides
NOTE: The following steps require an empty
NOTE: NOTE:
tote.
• Seal burst may cause flying debris or
product resulting in eye injury. Do not
force fully inflated seal into the tote. Do
not inflate the seal when not installed on
the ram plate. Wear safety glasses when
operating the system.
• The ram plate or the pump inlet can pinch
fingers, resulting in serious injury. Keep
hands and fingers away from the rim of the
tote when raising or lowering the ram. Keep
fingers away from the pump inlet.
1. Raise the ram to the highest position.
2. Position an empty tote under the ram plate.
3. Using Ram Jog, slowly lower the ram plate
to a point just above the opening in the top
of the tote. Position the empty tote within
the leg assembly for accurate ram plate
alignment with the tote.
4. If necessary, loosen the nuts and adjust the
tote guides to the desired position for the
tote. Tighten the nuts on the guides.
26
Triplex Sales
1-847-839-8442
www.triplexsales.com
Loading the the Tote
Loading Loading the
To prevent seal damage:
• Inflate the seal only after the ram plate
has been lowered into the tote opening.
Attempting to lower a ram plate with an
inflated seal can damage the seal.
• Inflating the seal should only occur when the
seal is properly installed on the ram plate
with corner stops in place. When inflating
the seal, do not exceed 15 psi.
1. At the pneumatic control panel:
a. Open the air shutoff valves for the air
controls (K) and pumps (L).
b. On the control panel, move the Ram
Position Selector (A) to the Ram Up
position. If the ram does not elevate,
increase the ram up air regulator (G)
pressure on the component panel.
Tote
Tote
NOTICE NOTICE NOTICE
3A5416L