Graco SaniForce STU Operation page 51

Event Event Event
Type Type Type Event Description Event Event Description Description
Devia-
Position sensor dirty
tion
Devia-
USB data format
tion
error
Devia-
USB file header error
tion
Devia-
USB not connected
tion
Devia-
USB operation failed
tion
Advisory USB Export
Successful
USB Import
Advisory
Successful
Record System
Depressurization
System Startup
Record
Record System Time
Changed
* Modules must be installed in the following order, from left to right:
X20BC1083
X20PS9400
X20CM8281
X20DS438A
X20AO2622
X20DO8322
3A5416L
Triplex Sales
1-847-839-8442
www.triplexsales.com
Electro-pneumatic Control Panel Display Screens
Error Error Error
Code Code Code Cause Cause Cause
L2CL
Position sensor reflectivity value
is low.
WSU2
The data in the file targeted by a
USB import contains incorrectly
formatted data.
WSU1 The information in the header
of the file targeted by a USB
import contains an incorrect or
incorrectly formatted Software
Part Number or Software
Version.
CCU0
A USB device is not connected
to the system.
WXU0 A USB import or export
command was not able to be
completed: an unspecified error
occurred during the operation.
EQUE USB Export operation completed
successfully.
EQUI USB Import operation
completed successfully.
P010 A depressurization sequence
was completed.
ELC0
The system started up and the
boot sequence completed.
ECT0 The system time was changed
by more than one minute.
Fix Fix Fix
Ensure the laser sensor and target
are clear of debris.
Verify data is formatted correctly.
No commas or new lines should be
inserted while modifying a file for
importing into the system.
Verify Software Part Number and
Software Version and correct and
formatted correctly in the file header.
Verify the USB device is compatible
with the system, formatted properly,
and inserted fully into one of the
USB ports on the back of the screen
unit. A USB device can take up to
10 seconds to be recognized by the
system once inserted.
check that the USB device is fully
inserted into the USB ports on the
back of the screen unit. If importing,
check formatting of data in files and
remove any unnecessary files from
the directory.
N/A
N/A
N/A
N/A
N/A
51