Table of Contents
Advertisement
Engineering Mode
Press RESET and ENTER keys for 2 seconds to enter Engineering Mode. The console will also beep for 1 second.
Top banner will blink first. Press UP or DOWN to select setting section. (Sound→odo→Sound)
While in Engineering Mode if there is no activity for 30 seconds, the console will switch STANDBY Mode. Pressing the RESET key
will exit the Engineering Mode. The console will not erase the setting value or ODO value under RESET mode. However, removing
the batteries will make the console return to original factory settings and the ODO value will turn zero.
A. Sound ON/OFF
•
Under Engineering Mode of the Audio ON/OFF setting. The SOUND sign will blink. Press ENTER to get into.
•
After pressing ENTER, the console will display "ON" or "OFF"
-
If the audio is on, the "ON" sign will blink.
-
If the audio is off, the "OFF" sign will blink.
•
Press ENTER to confirm and the console will return to Engineering Mode.
•
While in this setting if there is no activity for 30 seconds or pressing the RESET key, the console will switch STAND BY
Mode.
B. ODO
•
Under Engineering Mode of the ODO setting. The ODO sign will show.
•
When exercise time over 1:59:59, the LCD will display "H" sign.
•
Press UP or Down to switch to other Engineering mode.
•
While in this setting if there is no activity for 30 seconds or pressing the RESET key, the console will switch
STAND BY mode.
38
Advertisement
Table of Contents
