Spirit Fluid Rower 900 Series Owner's Manual page 23

Assembly Instructions
STEP 2 Mounting Rower Seat and Upper Mainframe
REQUIRED
Left/Right Side Rails [2]
Rower Seat [3]
※ Option for Seat High
– Please refer to
page 26.
STEP 3
REQUIRED
Mainframe [1]
Side Rails Assembly [2]
16x M8 Washers [7]
8x M8 Standard Nuts [8]
8x Nylon Nuts [9]
8x M8 x 45mm Bolts [11]
CAUTION
Nylon nuts must be
outside the standard nut
and washer to properly
secure assembly.
Note: Clean wheels and
tracks weekly with a soft
dry cloth in order to
decrease the rate of wear
on both wheels and track.
Nylon Nuts must be outside
Nylon
the standard nut and
Nuts
washer to properly secure
assembly.
To install the rower seat, spread the Left/Right Side Rails [2]
slightly and drop the Rower Seat [3] into the track.
Note Seat indentation must face rearward.
Left/Right Side Rails
Install the Mainframe [1] onto the Side Rail Assembly [2] as
shown. You will need 8x M8x45mm Bolts [11], 16x M8 Washers
[7], 8x M8 Standard Nuts [8] and 8x M8 Nylon Nuts[9].
Secure the front Lower Bracket first, then the Footboard but
DO NOT TIGHTEN. You may find that the Lower Bracket Bolts
can be difficult to access. You can tighten these bolts completely
once the Rower is standing in the vertical position so for the
moment, simply align and loosely thread lower bolts/nuts
Nylon
Nuts
23
ST
Rower Seat
Seat Indentation
.
M8x45mm Bolt
M8 Washer
M8 Nylon Nut
M8 Standard Nut