Assembly Instructions - Spirit Fluid Rower 900 Series Owner's Manual

Assembly Instructions

STEP 1 Installing the Rear Brace and Transport Wheel Assembly to Seat Rail
REQUIRED
Side Rail Left / Right [2]
Rear Brace [4]
Bungee Hook Mount [5]
Transport Wheel Assembly [6]
4x M6x15mm Bolts [10]
WARNING
Rotate Rear Brace to correct
orientation before assembly
onto Side Rails
WARNING
Note Transport wheels must be
mounted on the outside of Side
Rails As shown on the right.
Do not over tighten the Transport
Wheel Axle as it may inhibit
Transport Wheel rotation
Transport Wheel Assembly
M8 Washer
M8
Washer
M8 Nylon Nut
a )
Start with the Rear Brace and on the underside you
will find a Pre-installed bolt. From the hardware kit,
take the Bungee Hook Mount and install it onto the
Rear Brace as shown. Note the orientation of the
Brace and hook must be correct in order to hold the
end of the Bungee Shock Cord as depicted by the
arrow in the illustration, which points toward the front
of rower.
b ) Next, connect the Side Rail Left and Side Rail Right
[2] using 4x M6x15mm Bolts[10] and Rear
Brace[4].
DO NOT TIGHTEN.
Tip: Bump stops facing inside of rail for correct
assembly orientation.
c )
Once the Rear Brace and Side Rails are
. assembled, mount the Transport Wheel
Assembly[6] onto the Left/Right Side Rails[2].
Note: One washer on outside and one washer on the
inside of the side rail.
M8 x 60mm Bolt
Transport Wheel
Pre-installed Bolt
Bungee Hook Mount
Bump stop
Side Rail Left
M6x15mm Bolts
21
Towards Front of Rower
Rear Brace (Underside)
Side Rail Right
Rear Brace
*Bungee Hook Mount
towards to the floor
S
TEP