Reattaching The Rower Belt - Spirit Fluid Rower 900 Series Owner's Manual

Reattaching the Rower Belt

Velcro Facing Upward
Rower Handle
Belt/Bungee Pulley
Bungee Pulley
Bungee Shock Cord
STEP 5
Recoil tension will decrease over time as the Bungee Shock Cord stretches.
To increase recoil tension, simply push the Inner Clip out of the Bungee Hook
from behind, pull the required amount of bungee through the Inner Clip and
replace the Inner Clip into the Bungee Hook as shown below.
Hint:
Before reattaching the Inner Clip/
Bungee Hook, tie a slip knot under slight
tension at the lower bungee pulley. This will
keep the bungee under tension while
reassembling the Bungee Hook
Idle Wheel
STEP 1
Begin reattaching the Rower Belt by threading around the
Rower Belt Pulley with the Velcro side facing upward as
illustrated.
STEP 2
Next, thread the Belt around the Idle Wheel as shown.
Once around the Idle Wheel, attach the Rower Belt to the
Belt/Bungee Pulley. There is an obvious "lip" at the
attachment point.
STEP 3
Wind the Rower Belt onto the Belt/Bungee Pulley until the
Rower Handle is as it's furthest forward position.
STEP 4
Rethread the Bungee Shock Cord (on opposite side of the
Idle Wheel) back through the Bungee Pulleys and tie off at
the Attachment Point.
31
Inner Clip
Bungee Hook