iNetVu New Generation Service Manual
18. Install top level assembly on top of Base Bearing assembly ensuring to line up Chassis holes
with those on the Bearing.
19. Apply thread locker and fasten screws loosely until all have been inserted. Once all screws
are inserted fasten as per torque table which can be found at end of this article.
20. Slide belt onto AZ Reducer Shaft. Belt at the back end should be above Pulley for easy
installation.
Belt
Pulley
21. Slide belt onto Pulley, ensure belt teeth align in grooves on the Pulley.
C-COM Satellite Systems Inc.
Page 45 of 53
AZ
Reducer
Shaft