C-Com iNetVu 755A Service Manual page 24

iNetVu New Generation Service Manual
Installing the EL Pulley Belt
1. Place one end of the replacement belt on the clamp closest to elevation motor. Ensure last belt
tooth is placed on the last groove. Place top clamp and tighten into place.
2. Wrap belt over EL shaft, continuing around the Pulley assembly until belt reaches the bottom
clamp plate on the other side.
3. Ensure last belt tooth is placed on the last groove, place top clamp and tighten into place.
4. Tighten the (4) bottom clamp screws on the clamp that is furthest away from the EL motor.
Last Groove
C-COM Satellite Systems Inc.
Page 24 of 53