Spray On Corrosion Inhibitor - Application To Az/El Assembly - C-Com iNetVu 755A Service Manual

iNetVu New Generation Service Manual
2.1.7. Spray on Corrosion inhibitor - Application to AZ/EL
Assembly
It is highly recommended to apply corrosion resistance to bushings, bearings, and pins to maintain
high quality performance of the iNetVu
Recommended Materials:
Corrosion inhibitor certified to MIL-PRF-16173E Grade 2 (LPS #3 or equivalent)
Application:
Apply corrosion inhibitor to gear motor accessory shafts and keyless bushing as shown. Protect belts
from overspray and remove overspray from neighboring surfaces after application.
I. AZ gear reducer: end face with shaft, and high-speed input shaft extension.
II. EL gear reducer: end face of output shaft, Belleville Washers and torque limiter nut
(1201 only) and high-speed input shaft extension.
III. Keyless locking bushing on primary EL reduction driveshaft: exposed face and
fasteners.
EL Gear
Reducer Shaft
 If no Hex Sockets are installed on the EL/AZ Motor Reducer Shafts, please clean and apply
Corrosion inhibitor to the exposed metal.
If your system did not ship with the Hex Sockets installed on the Motor Reducer Shafts contact
C-COM Satellite Systems Inc.
®
Platform.
Face of Shaft
C-COM Satellite Systems Inc.
Page 12 of 53
AZ Gear
Reducer
Shaft