C-Com iNetVu 755A Service Manual page 21

iNetVu New Generation Service Manual
7. Mount Motor using mounting pin. Install (2) locking pin clips, one on each end.
Motor
Mounting Pin
8. Position the tension wedge below the motor mounting plate. Insert screw but do not tighten
until belt tension is set.
9. Slide the Belt onto the EL Reducer out-put shaft. Slide the belt onto lower Pulley, making sure
the belt teeth are aligned in the grooves. The tension wedge can be moved further to the rear
providing additional slack for the belt.
10. Proceed to tension the belt.
C-COM Satellite Systems Inc.
Page 21 of 53