Table of Contents
Advertisement
12 Cable Installation
Access points require an Ethernet connection from the WiMag Rack Assembly/WiMag
Loop Detector Replacement Card. This the AP with both power and data communication.
The following cable, which is suitable for duct installation and to maintain safe use, is
available from Siemens.
Part Number
998/4/88384/ETC
Note: It is recommended that installations that have existing infra-structure
should only use the armoured cable. The armoured cable can withstand the
stresses of pulling through restrictive/occupied ducts.
Hint: It is recommended that the Ethernet cable is pulled through all conduits,
prior to attaching the RJ45 termination jack. This ensures the termination is not
compromised in any way during the pulling procedure.
Note: Sharp bends in the cable are to be avoided. A minimum bend radius of
4x the cable diameter (50mm) should be observed.
Note: To maintain product safety, the armoured part of the cable must be
terminated at the controller end. For Siemens controllers the GB7:4/MC702
CET Gland kit is used.
1. Access points connect to the WiMag rack assembly via an Ethernet cable. This
cable should be standard Ethernet compatible, outdoor rated, 4-pair CAT5 (or
better).
2. The CAT5 cable is to be terminated with the RJ45 jacks (6671/147250/000) as a
standard straight-through Ethernet cable at both ends. Cables are to be terminated
according to the Table 13 : RJ45 Interface Cable Connection below.
3. Ethernet cables, from the junction's access points will enter the controller cabinet
through ducting at its base.
Version
11
Last Editor
Jeerh, Manpreet
Document
WIMAG GENERAL HANDBOOK
Name
Copyright © Siemens Mobility Limited 2012. All Rights Reserved.
Description
Armoured CAT5E cable for duct installation
Table 12 : DUCT Installation Cable
Page 69 of 117
Siemens Mobility Limited
Sopers Lane, Poole, Dorset
Status
Issued
Date
March 2020
Doc. No.
667/HB/47200/000
BH17 7ER
Advertisement
Table of Contents
