Table of Contents
Advertisement
Figure 59 : Mains Connection for 24V DC PSU (left: /200 variant;
If the auxiliary MCB is not available or all neutral block terminations are occupied, an
additional MCB can be fitted to the Master Switch Panel. This will be mounted on the DIN
rail behind the blanking panels and cabled from the mains in on the adjacent AUX MCB.
Instructions can be found in the documentation referenced below;
Part Number
667/GA/27121/000
Table 14 : Pole Mounting Kit Document Reference
WARNING: The controller Master Switch MUST be in the OFF position before
mains cabling is attempted. It must remain in the OFF position until all mains
cabling is completed. DO NOT cable the WiMag rack assembly unit while the
controller cabinet is live.
Version
11
Last Editor
Jeerh, Manpreet
Document
WIMAG GENERAL HANDBOOK
Name
Copyright © Siemens Mobility Limited 2012. All Rights Reserved.
right: /300 variant)
Document Description
OTU Supply Kit Assembly
Page 78 of 117
Status
Date
Doc. No.
Siemens Mobility Limited
Sopers Lane, Poole, Dorset
BH17 7ER
Issued
March 2020
667/HB/47200/000
Advertisement
Table of Contents
