Table of Contents
Advertisement
8. On completion of the settings – click on the 'Apply Settings' and allow the unit to
reboot
9. Disconnect the Ethernet connector from the front of the card.
10. Pull the interface card from the rack
11. Re-apply the 'configuration link' if removed.
12. Re-insert the card and re-connect the Ethernet cable from the front.
13. Re-connect to the interface card using the appropriate IP address, remembering
to re set your laptop/pc's Ethernet address accordingly.
14. In order for the interface card to interface with the controller, the GSPI address
needs to be set appropriately. This is achieved by using the rotary switch, as found
on the backplane. Reference Figure 30 below and section 13.4.1 for details.
15. Connect the next interface card, if applicable, and repeat steps 1 to 15. This also
applicable for a third card.
Figure 30 : Backplane Address Switch and Address Link
Version
11
Last Editor
Jeerh, Manpreet
Document
WIMAG GENERAL HANDBOOK
Name
Copyright © Siemens Mobility Limited 2012. All Rights Reserved.
Figure 29 : Apply Settings Screen
Page 43 of 117
Siemens Mobility Limited
Sopers Lane, Poole, Dorset
Status
Issued
Date
March 2020
Doc. No.
667/HB/47200/000
BH17 7ER
Advertisement
Table of Contents
