Table of Contents
Advertisement
8 General Installation Instructions
8.1 Special Tools Required for Non-Civils Based Installation
The following non-standard tools are likely to be required when involved in the installation
of a WiMag vehicle detection system.
1. Ethernet Jack Crimping Tool (8000 Series Crimping Tool, RJ45 WE/SS UT)
2. Ethernet cable checking tool (Greenlee NC-500 CAT5 Cable Tester)
8.2 Order of Installation
The following order of installation can be used as a suggestion, in order to ensure an
orderly implementation of the WiMag vehicle detection system.
1. Install the WiMag Sensors
2. Install the Ethernet cabling
3. Install Access points and repeaters
4. Terminate the Ethernet cables and confirm correct assembly
5. Install WiMag Communications Rack or WiMag Loop Detector Replacement Card
as required.
Version
11
Last Editor
Jeerh, Manpreet
Document
WIMAG GENERAL HANDBOOK
Name
Copyright © Siemens Mobility Limited 2012. All Rights Reserved.
Page 59 of 117
Status
Date
Doc. No.
Siemens Mobility Limited
Sopers Lane, Poole, Dorset
BH17 7ER
Issued
March 2020
667/HB/47200/000
Advertisement
Table of Contents
