Table of Contents
Advertisement
Prompting for Srce File for Operation on rmt3 located at 00-05-01-30
Please enter the following fields...
Enter Filename:
F1=Help
F5=Reset
13. While the microcode load takes place the display shows:
"Operation running, please standby"
The drive display shows the loading status messages at the bottom of the display.
14. When the microcode load completes, the initiator display shows:
Operation completed successfully!
The drive performs a soft power-on reset (restart the microcode).
15. Press F10 to exit the microcode load.
16. Press q to quit tapeutil.
Note: You must have administrator privileges to perform the following step.
17. Update the VPD data in the host pSeries (RS/6000) AIX by unconfiguring the
device (Example: rmdev -l rmt3). and reconfiguring the device (Example: mkdev
-l rmt3).
18. Press Ctrl+] to get a telnet> prompt, then type quit to stop the TELNET session.
19. Remove the CD-ROM from the CD drive.
Starting NT UTILITY (NTUTIL) from Windows NT or Windows
2000
For a complete update on device driver software, see the IBM SCSI Tape Drive,
Medium Changer, and 3592 Device Drivers: Installation and User's Guide.
You may require assistance from the customer during this process.
Follow this procedure to start NTUTIL.
1. Click the Start icon.
2. Select Program, Accessories, Command Prompt.
On the next screen, the cursor will be at the right of the default prompt C:\>. Any
data that is read will be stored in that drive/directory and any data written will
try to originate from the same drive/directory. If you wish to read to or write or
write from a different drive/directory, enter cd newdir (where newdir is a fully
qualified, valid drive) and dir to change to the new directory.
3. Enter ntutil. The following main menu appears on the screen.
F2=Refresh
F3=Cancel
F7=Commit
F10=Exit
Chapter 8. Drive Maintenance Procedures
B00000
/tmp/3592.fmr
F4=List
8-21
Advertisement
Table of Contents
