Connecting The Power Cords; Verifying Library And Drive Operation; Power Supply Cables - IBM System Storage TS3400 Tape Library Maintenance Information

Connecting the Power Cords

Figure 6-22. Power supply cables
For information regarding safety when servicing electrical equipment, refer to
Electrical Safety for IBM Service Engineers (S229-8124-09).
Important: Before attaching any electrical cables to the library, inspect the ac
To connect a power cord:
1. Plug one end of the power cord into the power connector on the rear panel of the
2. Plug the other end of the power cord into the nearest properly grounded power
3. Power ON the library by toggling the power switches on each power supply to
4. Wait for the library to initialize. This will take approximately 10 minutes.

Verifying Library and Drive Operation

To verify the library is operating correctly:
1. When the library is initialized, press the Enter button to move to the Password
2. If the password has been changed, ask the customer to enter the Operator Panel
6-20
TS3400 Tape Library Maintenance Information
grounding of the library. See "ac Grounding Inspection" on page 5-5.
library.
outlet.
the ON (|) position.
Note: If the Operator Panel does not initialize, check all cable connections, and
ensure that all cartridge magazines are tightly closed and all power
supply switches are in the ON position.
screen.
password. Otherwise, enter 0000, the default password. The top menu screen
appears.
If necessary, adjust the contrast of the library display. Select Configuration → Op
Panel Settings → LCD Contrast to change the display contrast.